End of Well

We should be finishing up this well sometime tonight and probably getting underway tomorrow. That means I’ll be even more busy (with less time to blog) than usual.

I’m not used to these drilling rigs yet. I’ve only been doing it off and on for the last couple of years. I’m a mariner, not a driller. 😉

I do find it amazing how fast they get the job done on these rigs over here in Africa. In the Gulf of Mexico (GoM), I seem to remember it taking many months to drill a well.

Here it seems to take them only a few weeks. I’m sure part of the reason is that these ships are the latest and greatest (so far)- 6th generation dual derrick drill ships. They can use both derricks at once, that saves them a LOT of time.

Ocean Rig Olympia

Ocean Rig Olympia

I hear this next job will only take a week or so. That one is only putting down the ‘top-hole’, it’s not the same thing as drilling a well.

This kind of work keeps me MUCH more busy than I usually am offshore. I’m learning a lot, which is always good. I just hope it doesn’t get too stressful (it’s ALWAYS stressful when we’re moving).

It should only take us a couple of hours to get there once we finally get underway. The new well is only about 12 miles from where we’re at right now. What takes time is getting underway and then getting set up again once we reach our new location.

Our drillers and subsea guys have to pick up all the riser and the BOP. We (DPOs and ROV guys) have to pick up all our transponders and then secure our transducer poles for our acoustic reference system. All that can take quite a while.

When we get to our new location, we have to do all that in reverse. We will also spend a lot of time and effort to calibrate all our equipment so that it all works as well as possible.

I’m looking forward to the move, but a little nervous too. :-/

PS- I was on the Olympia last hitch, but these are not my photos, (I got them from googling “drillships”)